2. Product Specifications 3. Disassembly & Reassembly 4. Troubleshooting AUTO AUTO EXIT EXIT MENU MENU 5. Exploded View & Parts List CN15VS 6. Electrical Parts List 7. Block Diagram 8. Wiring Diagram 9. Schematic Diagrams AUTO AUTO EXIT EXIT MENU MENU 10.
1 Precautions Follow these safety, servicing and ESD precautions to prevent damage and to protect against potential hazards such as electrical shock. 1-1 Safety Precautions 1-1-1 Warnings For continued safety, do not attempt to modify the (READING SHOULD circuit board. NOT BE ABOVE 0.5mA) Disconnect the AC power and DC Power Jack before servicing.
3 Disassembly and Reassembly This section of the service manual describes the disassembly and reassembly procedures for the CN15V* monitor. WARNING: This monitor contains electrostatically sensitive devices. Use with caution when handling these components. 3-1 Disassembly Cautions:1. Disconnect the monitor from the power source before disassembly. 2.
4 Troubleshooting Notes: 1. Before troubleshooting, setup the PC’s display as below. • Resolution: 1024 x 768 • H-frequency: 48 kHz • V-frequency: 60 Hz 2. If no picture appears, make sure the power cord is correctly connected. 3. Check the following circuits. •...
Page 19
5 Exploded View & Parts List 5-2 Multi Media Base CN15V*...
Page 20
5 Exploded View & Parts List 5-3 Pivot-MultiMedia Base CN15V*...
Page 21
5 Exploded View & Parts List 5-4 Angle-Pivot Base CN15V*...
Page 22
5 Exploded View & Parts List 5-5 Wire-Frame Base CN15V*...
Page 23
5 Exploded View & Parts List Memo CN15V*...
Page 24
4 Troubleshooting 4-2 No Video Power indicator is green Does the clock pulse Does the H-sync pulse appear Check CN102. appear at Pin 44 of IC105? at Pin 150 of IC105? Replace IC105. Do the sync pulses Replace IC105 or check its appear at Pin 43 of IC105? related circuit.
Page 25
4 Troubleshooting 4-3 User Controls Don’t Work Does the DC level change at Check the buttons. Pin 35 and 36 of IC311 when you (SW801~SW808) push the front panel button? Refer to 4-4 No OSD Display. 4-4 No OSD There is video but no OSD. IC105 #46,47,55,56,63,64 While pushing a front control button does Do sync signals appear at Pin 44,...
Page 26
4 Troubleshooting 4-6 Microphones Don’t Work Does the PC’s sound Check the PC’s sound program program operate well? and compatibility. Is the connection between the PC Connect the cable between the PC and monitor secure? and monitor. Check the connection between Is the Internal Microphone CN808 on the Audio PCB and the connector attached?
Page 27
8. Remove 5 stopper hings from the Bracket Bottom. 9. Remove the Stand Base from the Stand Assembly. 3-2 Replacement Order of Lamp Assemblies (CN15VS/CN15VO : Samsung Panel) (CN15VS/CN15VO : TORISAN Panel) 1. After confirm there is nothing on the disk...
Page 28
3 Disassembly and Reassembly 3. Please take out the lamp unit from the LCD module. 4. Please fix the new lamp units on the LCD module : opposite process 2 and 3 Replacement of lamp unit should be done at the power off state and recommanded clean bench condition.
Page 29
3 Disassembly and Reassembly Memo CN15V*...
2 Product Specifications 2-2 Pin Assignments Sync 15-Pin Signal Cable Connector Type Separate Composite Sync-on-green Pin No. Green Green Green + H/V Sync. Blue Blue Blue GND (DDC Return) GND (DDC Return) GND (DDC Return) GND-R GND-R GND-R GND-G GND-G GND-G GND-B GND-B...
2 Product Specifications 2-3 Timing Chart This section of the service manual describes the timing that the computer industry recognizes as standard for computer-generated video signals. Table 2-1. Timing Chart Mode VESA VGA1/70 Hz VGA3/60 Hz VGA2/70 Hz 800/60 Hz 640/72 Hz 640/75 Hz 800/56 Hz...
Page 32
2 Product Specifications Table 2-1. Timing Chart Continued Mode VESA MAC. 1024/60Hz 1024/70Hz 1024/75Hz 640/67 Hz 832/75 Hz 800/72 Hz 800/75 Hz 640 x 480 832 x 624 1024x768 1024x768 1024x768 800 x 600 800 x 600 Timing fH (kHz) 35.000 49.726 48.077...
1 Precautions 1-2 Servicing Precautions WARNING: An electrolytic capacitor installed with the wrong polarity might explode. Caution: Before servicing units covered by this service manual, read and follow the Safety Precautions section of this manual. Note: If unforeseen circumstances create conflict between the following servicing precautions and any of the safety precautions, always follow the safety precautions.
Page 34
Samsung Electronics Co.,Ltd. 416, Maetan-3Dong, Paldal-Gu, Suwon City, Kyungki-Do, Korea. Tel : +82-31-200-7920 Fax : +82-31-200-7802 Printed in Korea P/N : BN68-00097K-00 http://www.samsungmonitor.com (SyncMaster Worldwide) http://www.samsung-monitor.com (SyncMaster USA) http://www.samtron.com (SAMTRON Worldwide) http://www.sec.co.kr/monitor (Korea)