Mounting And Adjusting The Squeegee - Dustbane Hurricane 400 XTT Operation Manual

Automatic scrubber
Hide thumbs Also See for Hurricane 400 XTT:
Table of Contents

Advertisement

6.2. Mounting and adjusting the squeegee

To mount the squeegee on the machine, proceed as follows:
1. Check that the squeegee mount (ref. 2) is raised, otherwise lift it by means of the squeegee lever (ref. 5);
2. Insert the suction hose sleeve (ref. 4) fully into the squeegee;
3. Slacken the two knobs (ref. 3) at the centre of the squeegee;
4. Insert the two threaded pins into the slots on the support (ref. 2);
5. Fix the squeegee by tightening the two knobs (ref. 3).
The squeegee blades scrape the film of water and detergent from the floor and prepare the way for perfect
drying. With time, the constant rubbing makes the edge of the blade in contact with the floor rounded and
cracked, reducing the drying efficiency and requiring it to be replaced. The state of wear should be checked
frequently.
For perfect drying, the squeegee must be adjusted in such a way that the edge of the rear blade bends during
operation by about 45° with respect to the floor at every point. Adjust the angle of the blade during operation
by regulating the height of the two wheels positioned behind the squeegee (ref. 1).
6.3. Moving the machine when not in operation
Fig./Abb./
To move the machine, proceed as follows:
1. Raise the squeegee;
2. Push the head pedal down then to the right to raise the head;
3. Move the machine as follows:
Non-traction units: push or pull;
Traction units: to move the machine forwards, press the button/selector and then operate the drive lever.
To move the machine backwards, press the button/selector again then operate the drive lever. Speed can
be varied by the potentiometer knob.
Do not leave the machine unattended or parked with the head lifted or the key inserted
in the emergency button.
Important
4. Once you have reached your destination, lower the head by pressing the release pedal down and to the left,
Fig./Abb./
then release it.
Never work without the brushes and pads perfectly installed.
Important
Fig./Abb./
9
1
2
10
7
Fig./Abb./
3
4
5
Fig./Abb./
8
11
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hurricane 510 xttHurricane 400 ecoHurricane 400 xtt tractionHurricane 510 xtt tractionHurricane 610 xttHurricane 670 xtt ... Show all

Table of Contents