Care And Cleaning - Catler 400 Series Instructions For Use Manual

CARE AND CLEANING

Before cleaning your kettle, always
disconnect the mains cord from the electric
outlet fi rst.
Cleaning the outer case KETTLE
To clean the kettle's outer surface, please use
a damp cloth; to polish, use a dry cloth.
For cleaning the outer case, do not use
chemicals, wire brushes or abrasive
detergents.
Removing mineral deposits
Tapped water may contain minerals that may
deposit inside the kettle and water gauge
and lead to colouration after some time. To
remove the deposits, proceed as follows:
1. Fill your kettle to 2/3 of its level with
1 portion of vinegar and 2 portions of
water. Boil the solution and leave stand in
the cattle overnight.
2. Empty your kettle and then boil clean
water twice. The kettle is then ready for
further use.
WARNING:
DO NOT SPLASH WATER OR ANY OTHER
LIQUID ONTO THE KETTLE OR ANY OF ITS
PARTS OR ACCESSORIES. DO NOT WASH THE
KETTLE, BASE, MAINS CORD AND PLUG UNDER
RUNNING WATER AND DO NOT IMMERSE
THEM IN WATER OR ANY OTHER LIQUID.
The base heating element is made of high
grade stainless steel. Brown stains that may
appear during use are mineral deposits from
the boiled water. This is no corrosion in any
case.
Storage
Before storing your kettle, make sure
it's turned on, clean and dry. Check that the
lid is closed properly. Wrap the mains cord
around the bottom of the base. Store your
kettle vertically and never put anything on
the lid.
NOTE
15
CARE AND CLEANING