Catler 400 Series Instructions For Use Manual page 15

Fast selection - heating water to 80°C
If you need to heat water to 80 °C, proceed as
follows:
1. Perform steps 1 to 3 from "Heating water
to a required temperature".
2. Hold down the - and + buttons
simultaneously for about 2 seconds.
A short acoustic signal will sound. 80°C
will appear on the display.
3. Press the power button to switch the
kettle on.
4. If the power button is not pressed within
6 seconds, the kettle will be put into
standby and the LCD will show current
temperature.
The last set heating temperature will be stored
in the kettle's memory. If you want to warm
up to the same temperature again, press the
power button. If you wish to heat to another
temperature, use the +/- buttons to set the
required temperature and press the power
button.
If you need to check the set temperature during
heating, hold down the + or – button for
about 2 seconds. The set temperature will start
fl ashing on the display for about 6 seconds.
Then, the display will show the temperature
progress during heating.
"Keep-warm" mode (temperature
keeping)
• The "Keep-warm" mode keeps the set
temperature for a maximum of
60 minutes. When this time has elapsed,
the kettle will automatically revert to
standby.
• The mode will be enabled automatically
when the heating has fi nished. The power
button will be backlit in yellow as long as
the "Keep-warm" mode is active.
• While the kettle is in the "Keep-warm"
mode, it will switch on and off regularly.
This is a normal state when the kettle
keeps the set temperature.
• To cancel the "Keep-warm" mode, press
the power button or remove the kettle
from its base.
• If the set temperature is within 90 - 100°C,
the water will automatically cool down
to 90°C and the kettle will maintain this
temperature (90°C) inside. As soon as the
temperature reaches 90°C, acoustic signal
will sound and the display will show 90°C.
This is a common safety precaution to
prevent the water from boiling out and
possible damage to the kettle.
• When about 60 minutes have elapsed,
acoustic signal will sound 5 times and the
"Keep-warm" mode will turn off . The LCD
will show the current water temperature
inside the kettle. As the water
temperature inside the kettle drops, the
display readout will also decrease.
NOTE
If you press the +/- button briefl y while in the
"Keep-warm" mode, the temperature the kettle
has been warmed up to will be fl ashing on the
display for about 6 seconds. Then, the display
will revert to the current temperature.
Stand-by mode
The kettle will automatically switch to stand-
NOTE
by mode after 30 hours of inactivity. If the
"Keep-warm" mode is enabled, the kettle will
not switch to standby until the "Keep-warm"
mode has been disabled.
To switch on from the standby mode, press
+/- buttons or the power button.
NOTE
13
OPERATING YOUR KETTLE KE 4014