Operating Your Kettle Ke 4014 - Catler 400 Series Instructions For Use Manual

OPERATING YOUR KETTLE KE 4014

Before fi rst use
Before fi rst use, remove all packaging and
advertising labels / stickers from the kettle.
Before using your kettle to prepare hot drinks
for the fi rst time, allow clean water to boil.
Fill the cattle with clean water, bring to a boil
and then pour the water out. Repeat this
procedure 3 to 4 times. The kettle is then
ready to be used for preparing hot drinks.
Your kettle will only operate correctly if
placed on its base connected to an electric
outlet and if the power button is in the on
position. As soon as the water boils, the
kettle will switch off automatically.
Heating water to a required temperature
1. To fi ll the kettle with water, remove it
from its base and detach the lid. Fill the
kettle with the required amount of water.
Do not fi ll the kettle below the minimum
or above the maximum level mark.
Lack of water would lead to turning the
kettle off before boiling. If the kettle is
overfi lled, the boiling water might splash
out.
2. Put the lid back and make sure it's fi rmly
closed. Place the kettle on its base.
Connect the mains cord to a power
outlet.
3. An acoustic signal will sound. The LCD
displays"--".
4. Use the +/- buttons to set the
temperature from 50 to 100°C in 5°C
steps. The initial temperature after
turning on for the fi rst time is 80°C.
5. Press the power button to start heating.
The button will be backlit in red.
6. As soon as the temperature inside the
kettle reaches 30°C, you will be able to
watch it rise until the set value has been
reached.
12
OPERATING YOUR KETTLE KE 4014
7. When the temperature inside the kettle
reaches the set value, an acoustic signal
will sound 5 times and the button will be
backlit in yellow.
8. Disconnect the mains cord from the
power outlet, remove the kettle from
its base and pour the water in prepared
cups.
If you need to turn the kettle off immediately,
press the power button. An acoustic signal will
sound and the heating process will stop.
Fast selection - heating water to 100°C
1. If you need to heat water to 100°C,
proceed as follows:
2. Perform steps 1 to 3 from "Heating water
to a required temperature".
3. Hold down the + button for about
2 seconds. An acoustic signal will sound.
100°C will appear on the display.
4. Press the power button to switch the
kettle on.
5. If the power button is not pressed within
6 seconds, the kettle will be put into
standby and the LCD will show current
temperature.
Fast selection - heating water to 60 °C
If you need to heat water to 60 °C, proceed
as follows:
1. Perform steps 1 to 3 from "Heating water
to a required temperature".
2. Hold down the - button for about
2 seconds. A short acoustic signal will
sound. 60°C will appear on the display.
3. Press the power button to switch the
kettle on.
4. If the power button is not pressed within
6 seconds, the kettle will be put into
standby and the LCD will show current
temperature.
NOTE