Safety 1st Summit Deluxe Instruction Manual page 13

4. Thread Harness Strap
Thread the harness down
through slot on left side
of plastic shell
through slot on right side (2).
NOTE:
1
of the harness strap loop
faces the buckle before
2
starting.
Take both ends of the
harness and make them
even in length.
NOTE:
tightening strap is between
the harness strap and shell
as shown.
5. Thread harness straps
5
through each buckle tongue
(3). Thread the chest clip
(4). Do the same to the other
harness end. Do Not twist
harness.
4
Push harness ends through
slots in headrest (5).
3
6. Thread Harness OVER
Metal Bar
Pull harness through the
back. Make sure the
harness goes OVER the
metal bar, BETWEEN metal
bar and plastic handle of the
harness/headrest adjuster.
23
Failure to place harness over the metal bar,
between the metal bar and plastic handle, can
(1) and up
result in serious injury or death.
Make sure sewn end
Make sure harness
Harness system must be reattached correctly.
Failure to follow these warnings can result in
serious injury or death.
7. Attach Harness Straps
to Splitter Plate
Fit loops on harness ends
completely on the splitter
plate.
24