Related Manuals for Bonsaii C221-A
Summary of Contents for Bonsaii C221-A
- Page 1 DocShred Pro Paper Shredder Instruction Manual C221-A 15 Sheets Cross Cut C221-B 12 Sheets Micro Cut Customer Service: 1-844-728-6917 support@bonsaii.com...
- Page 2 Dear customer, Thank you for purchasing this quality product. Please carefully read through this manual before first using the device, paying particular attention to the safety warnings. You can find information on how to contact support at the end of these operating instructions. Safety precautions: Cautions: 1.
- Page 3 Operation instruction： Parts & Function 1.Touch Switch: REV/AUTO/FWD Power Light: Blue Overload Light: Flashing Red Overheat Light: Red 2. Feed Slot for Paper & Credit Card 3. Handle Place 4. Wastebasket 5. Transparent Window 6. Casters 7. Main Power Switch Installation ①...
- Page 4 Shredder capacity The C221-A is capable of shredding up to 15 sheets of paper (DIN A4, 75g/m² ) into cross cut at once. Paper width may not exceed 220mm. When shredding small pieces of paper, such as envelopes or credit card receipts, the paper should be inserted in the middle of the slot.
-
Page 5: Troubleshooting
Insert the card into the top center of the feed opening. You can only cut up one credit card at the time. Overloading If you insert too much paper over the maximum shred capacity of the shredder, the indication light will be red flashing, and the cutting unit will stop rotating. - Page 6 Notice Never use flammable synthetic oil, petroleum based or aerosol lubricants to oil your cutting unit. Use only a vegetable oil-based lubricant in a non-aerosol container. C221-A/B Technical Specifications: Model No. C221-A C221-B Cutting Capacity Max. 15 sheet Max. 12 sheet...
Need help?
Do you have a question about the C221-A and is the answer not in the manual?
Questions and answers
I just received my bonsai shredder a d will not start
The Bonsaii C221-A shredder may not start due to the following reasons:
1. It is not plugged into a power source or the main power switch is off.
2. The waste bin is not fully inserted into the shredder housing.
3. The power supply voltage is too low or there is no power supply.
4. The machine head is not aligned with the waste bin.
5. The shredder has entered protection mode due to overheating and needs to cool down.
This answer is automatically generated