Table of Contents
Advertisement
3.2.2.1
Water type selection
The A1 determines depth by measuring
pressure using water density as a constant.
A 10m/33ft depth in salt water corresponds
approximately to 10.3m/34ft in fresh water.
By pressing the +/UP or -/DOWN buttons
you may select either salt or fresh water.
The selection is confirmed by pressing the
SEL/ESC button.
F
NOTE: This setting will adjust the
depth on all modes: SCUBA, GAUGE
and APNEA.
26
3.2.2.2
Microbubble level selection
By pressing the SEL/ESC button in
this menu the Microbubble level will be
highlighted. By pressing the +/UP or -/
DOWN buttons you may select your
personal setting from L0 up to L5.
L5 is the most conservative setting. The
selection is confirmed by pressing the SEL/
ESC button.
F
NOTE:
More
about
microbubble levels can be found in
section 4.7 Diving with MB-levels.
3.2.2.3
Dive display type
In this menu the display type while diving
in SCUBA and GAUGE modes can be
selected. You will find a more detailed
description about diving with light and
classic displays in chapter 4.1.2.1 SCUBA
mode display selection and 4.1.2.2
GAUGE mode display selection.
diving
with
A1 USER MANUAL
Advertisement
Table of Contents
