Installation And Location - Daitsu FSTD SLIM - EC FLEX Series Installation And Maintenance Manual

Installation and Location

The unit location should be established by the installation designer, services engineer or by a technically competent person
before installation. It should take into account the technical requirements as well as the relevant current laws and
regulations. The fan coil should be installed by a qualified company, also in accordance with the relevant laws and regulations
of the country of installation.
The fan coils are designed for exposed installation. All the models are designed to be floor free standing, wall mounted or
suspended from the ceiling. Installation should allow the treated air to circulate freely throughout the room and leave
sufficient space to access the unit, in order to carry out maintenance or servicing operations.
FOR FLOOR FREE STANDING
1. Open the top left and right covers to loosen the 8 screws.
2. Lift and remove the front panel.
3. Install the unit on the wall with ABS supporting feet.
4. Complete the hydraulic connection and check for leakage.
5. Complete the electrical connection as shown in the wiring
diagrams.
6. Remount the front panel, return air grille and filter.
FOR WALL-MOUNTED WITH BOTTOM RETURN
1. Open the top left and right covers to loosen the 8 screws
2. Lift and remove the front panel.
3. Keep a minimum clearance of 80mm from the floor.
4. Secure the mounting brackets to the wall, then suspend the unit
by the mounting brackets, as shown in figure.
5. Complete the hydraulic connection and check for leakage.
6. Complete the electrical connection as shown in the wiring
diagrams.
7. Remount the front panel, return air grille and filter.
FOR CEILING-MOUNTED
1. Open the top left and right covers to loosen the 8 screws.
2. Lift and remove the cover.
3. Secure the mounting brackets to the ceiling, then suspend the
unit by the mounting brackets. To correctly position flanges
and brackets, see the dimensional data.
4. Complete the hydraulic connection and check for leakage.
5. Complete the electrical connection as shown in the wiring
diagrams Make electrical connection as shown in the wiring
diagrams.
6. Remount the front panel, return air grille and filter.
Page 19 of 71
SK2019 FSTD-SLIM-EC-FLEX-001_01