Table of Contents
Advertisement
Available languages
Available languages
Remote Control
Wall Controller
No.
Element
1
2
3
4
DIP switches
5
6
Display
7/8
▲ and ▼
9
SELECT
10
Infrared sensor
11
MUTE
12
On/off switch
13
RJ-45 port
No.
Element
1
MUTE
2
SOURCE +/-
3
TREBLE +/-
4
VOLUME +/-
5
POWER
6
BASS +/-
7
BALANCE +/-
8
Battery
compartment
Note: When actuating a button, always direct the remote control towards the
sensor on the wall controller. There must be no obstacles between remote
control and the sensor. If the range of the remote control decreases, the
battery is probably exhausted and must be replaced.
Function
Lights up during volume settings
Indicates the connection status to the amplifier
Lights up during sound settings
Selects the PA zone (see printing)
Lights up during muting
Indicates the signal source, PA zone, volume and sound settings
Adjust the values
Selects the settings for the PA zone
For the included remote control or one of the signal sources when using IR
emitters (accessory) for IR extension
Mutes the PA zone
Turns the PA zone on and off
The button lights up white when the PA zone is turned off and blue then
the PA zone is turned on
For connecting the hub via a network cable (max. 200 m)
20
Function
Mutes the PA zone
Selects the signal source
Adjusts the high frequencies
Adjusts the volume
Turns the PA zone on and off
Adjusts the low frequencies
Adjusts the balance L/R of the speakers in
stereo mode
For two 1.5 V AAA batteries
Advertisement
Table of Contents
