Kohler 1093479-2-B Installation And Care Manual page 12

Remote Holder
Anchors
5. Install the Remote Holder
Choose a mounting location for the remote control holder that is
easily accessible while sitting on the seat.
The remote control holder can be installed using screws or
double-sided tape. Follow the instructions for your chosen
installation method.
Install Using Screws
Position the remote control holder at the desired mounting
location with the rectangular indent toward the bottom (as
shown).
Using a pencil, mark the two mounting hole locations.
For installation to stud or other wood surface: Drill 1/16" holes
at the marked locations.
For installation using wall anchors: Drill 1/4" holes at the
marked locations and install anchors.
Position the holder so the rectangular indent is toward the bottom
and secure with the screws.
Install the caps to cover the screws.
Position the remote control into the holder with the user preset
icons facing up.
Install Using Double-Sided Tape
Remove the paper from one side of each of the tape squares.
1093479-2-B
If used, apply tape here.
Screws
Covers
12
Remote
Kohler Co.