ZENER VARIDRIVE SOLUTIONS
[SETUP for a pressure Control System]
Checking the Transducer Feedback
It is possible to check for the transducer signal by viewing its present value in the service menu. In general, when power is first
applied it is reasonable to expect that there is no pressure in the plumbing system. From the meter display:
0.0Hz
0%
EN LOC
ESC
1.
Press
and the display will show:
2.
Press
twice to display:
3.
Press
to display:
4.
Press
several times to display:
5.
Press
to display:
6.
Press
once to display:
If the displayed value is significantly less than 4mA then there may be a problem with the transducer or its wiring. Review the
transducer wiring and check that it is wired in accordance to the manufactures documentation. Press
return to the meter display.
IM00130
0.0kW
P a g e
ZENER ECODRIVE® 8000
Pressure Control
set up (default)
S00 SERVICE
R40
ST
V5.2.
Analogue
Inputs
AI(10,11) 0.00V
AI(32,34) 4.00mA
| 37
several times to
ESC
20/07/2018 3:59 PM