Zener ECODRIVE 8000 Installation Manual Supplement page 38

ZENER VARIDRIVE SOLUTIONS
2 SETUP for a pressure Control System
This setup guide is for a 'Pressure Control' application assuming the application 'SOLAR Pressure Control' is selected and all
control and sensor wiring is as per wiring detailed in the manual.
Quick Setup Guide
Before proceeding further with this quick setup guide, ensure the following has been checked and/or completed.
1. Read all safety warnings.
2. Check all earthing, power wiring and voltages are correct and within specification and is safe to operate before applying
power.
3. Check control wiring is correct and all external wiring and level switches are wired & operate correctly.
4. Check motor direction (in manual or local mode).
5. Load application – refer to page 25.
6. Check irradiance sensor (if fitted) – refer to page 26.
This guide will step through the following.
7. Configure the 'SOLAR & PRESSURE CONTROL' application parameters.
8. Determine and enter the minimum speed & Hibernation levels (if required) for the pump.
9. Enter the Set-point variable speed.
10. Check system functionality under various conditions.
IM00130
ZENER ECODRIVE® 8000
P a g e | 36 20/07/2018 3:59 PM