Zener ECODRIVE 8000 Installation Manual Supplement page 32

ZENER VARIDRIVE SOLUTIONS
1 TANK FILL (or BASIC PUMPING)
This setup guide is for a 'Tank fill' application assuming the application 'Tank Solar' or 'Tank Solar AC' is selected and all control
and sensor wiring is as per wiring detailed in the manual.
Quick Setup Guide
Before proceeding further with this quick setup guide, ensure the following has been checked and/or completed.
1. Read all safety warnings.
2. Check all earthing, power wiring and voltages are correct and within specification and is safe to operate before applying
power.
3. Check control wiring is correct and all external wiring and level switches are wired & operate correctly.
4. Check motor direction (in manual or local mode).
5. Load application – refer to page 25 of manual.
6. Check irradiance sensor (if fitted) – refer to page 26 of manual.
This guide will step through the following.
7. Configure the solar application parameters.
8. Determine and enter the minimum speed for the pump.
9. Enter the operating speed.
10. Check system functionality under various conditions.
IM00130
ZENER ECODRIVE® 8000
P a g e | 30 20/07/2018 3:59 PM