Advanced Troubleshooting; Block Diagrams - Keysight N9040B Option 508 Service Manual

Hardware Options
Option H1G, 1 GHz Analysis Bandwidth Assembly

Advanced Troubleshooting

This procedure will verify signal levels at the output of the A15 Front End
Control assembly, the IF Output of the A21 Wideband Analog IF (B2X assy), the
100 MHz reference from the A16 Reference assembly, and the rear panel IF 2
output from the H1G Analog IF assembly. Refer to
Block
1. This procedure uses an external signal source connected to the analyzer's
2. UXA analyzer settings:
3. Locate the A15, Front End Control assembly in the instrument and remove
252
Diagram,".
RF Input port.
External source settings:
Frequency: 1 GHz
Amplitude: -20 dBm
Connect the source 10 MHz Out to the signal analyzer Ext Ref, so
both instruments share a single frequency reference.
Mode: IQ Analyzer, Complex Spectrum
Meas Setup, IF Path, 1 GHz
Center Frequency: 1 GHz
Span: 1 GHz
Atten: 10 dB
the cable from A15J901 (IF Out). Connect a signal analyzer to this J901
MMCX female connector. One way to make this connection is to order a
cable, 8121-2608 or 8121-2027 (this is the W16, SMA to MMCX cable
used in the UXA).
Set the measuring signal analyzer to the setting shown in
signal amplitude at 750 MHz should be about -40 dBm as shown in
11-8.
Keysight Technologies N9040B UXA Signal Analyzer Service Guide
Figure 11-5, "Option H1G
Figure 11-7. The
Figure