Table of Contents
Advertisement
PROCEDURE TO STORE A ROLLING CODE TRANSMITTER
Compatibility table
ROLLING CODE GROUP 3
PRODUCER
MODEL
CARDIN
S449QZ, S437TX
SOMMER /
4013, 4013TX, 4014, 4020, 4022TX,
APERTO FM
4025, 4026
1) Enter set up
Press and hold key 4 (PROG) then press key sequence 1,2 and 3 (pic. A). Green led will start to blink
rapidly (pic. B).
1
2) Select channel
Press the key (channel) on which you want to store the original transmitter (key 1 for channel 1, pic.
C), both led will be lit steady (pic. D).
1
3) Program EGO
Transmit keeping the original transmitter about 5 cm far from EGO (pic. E).
When the frequency is detected, the red led goes off, then when the code is detected the green
led goes off too, finally to confirm the success of the procedure the red led will blink for about 3
seconds (pic. F).
If you want to add another code on a different channel please goes back to step 2 within 3 seconds
(until the.green led blinks rapidly).
22
2
3
original
GROUP 3
Compatibility table
EGO
ROLLING CODE GROUP 3
PRODUCER
TELCOMA FM
4
pic. A
pic. C
5cm
MODEL
FM402, FM402E, FM404E
FLASH
FLASH
FLASH
pic. B
pic. D
pic. E
EGO32
EGO User manual
Advertisement
Table of Contents
