Table of Contents
Advertisement
PROCEDURE TO STORE A ROLLING CODE TRANSMITTER
Compatibility table
ROLLING CODE GROUP PRASTEL
PRODUCER
PRASTEL
1) Enter set up
Press and hold key 2 and 3 for at least 3 seconds until the green led starts to blink faster, then rele-
ase (pic. A).
2) Select channel
Press the key on which you want to store the new code 4 times. The led blinks 3 times for confirma-
tion (pic. B).
3) Add EGO to the receiver
This procedure must be done nearby the automation's receiver. Get closer the receiver and:
a) Press key 1 and 2 on the original transmitter then release; led will light steady for about 2 se-
conds (pic. C).
b) When the led goes off the original transmitter send a signal to the receiver to go in program-
ming mode. The receiver remains in this state for 10 seconds during which you have to press the
EGO key (channel) you want to add into the receiver (pic. D). Every entry reset the 10 seconds
count-down, so it is possible to add another.
Receiver will exit from programming mode automatically after 10 seconds has passed from the last tran-
smission. If the procedure fails, wait 20 seconds before trying again from step 1.
20
GROUP PRASTEL
MODEL
TC4E, BFOR, MPSTL1E, MPSTL2E, MPSTL4E, MPSTP2E, MPSTP2
2
3 sec
3
4 times
1
2
EGO32
>>>
Slow
blinking
>>>
pic. C
Fast
pic. A
blinking
FLASH
pic. B
3
x
pic. D
EGO User manual
Advertisement
Table of Contents
