Table of Contents
Advertisement
If the procedure fails because the original transmitter is not compatible, after 10 seconds
both led will start to blink alternately.
PROCEDURE TO STORE A ROLLING CODE TRANSMITTER
Compatibility table
ROLLING CODE GROUP 2
PRODUCER
MODEL
FAAC
DL2 868 SLH, DL4 868 SLH, T2, T4, TML2 SLH, TML4, SLH, XT2 SLH, XT4 SLH
GENIUS
AMIGO JA 332, AMIGO JA 334, KILO TX2, KILO TX4
1) Enter set up
Press and hold key 4 (PROG) then press key sequence 1,2 (pic. A). Green led will start to blink rapidly
(pic. B).
2) Select channel
Press the key (channel) on which you want to store the original transmitter (key 1 for channel 1, pic.
C), both led will be lit steady (pic. D).
3) Program EGO
Press and hold key 1 and 2 for about 2/3 seconds and release: led on original transmitter will blink.
Transmit seed code keeping the original transmitter about 5cm far from EGO (pic. E) pressing the
key (channel) you intend to store into EGO. When the code is detected EGO red led goes off and
green led will start to blink, at this point you can release the key. (pic. F).
1
2
FAAC
GENIUS
EGO User manual
GROUP 2 (FAAC and GENIUS)
1
2
1
1
1
2
2
FAAC
4
pic. A
pic. C
5cm
1
2
EGO
pic. B
pic. D
pic. E
>>>
FLASH
FLASH
FLASH
pic. F
15
Advertisement
Table of Contents
