Pottery Barn Marble and Metal Floor Storage Assembly Manual

● Please read all instructions carefully and completely before beginning assembly.

● Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware.

● Use the parts and hardware lists to identify and separate each of the components included.

● For your safety and ease, assembly by two people is recommended.

Hardware Included:

A. 4mm Allen Key (1pc)

D. Left & Right side frame (1pc each)

1. Carefully remove all parts and hardware from packaging and lay out on a clear work surface.

2. Connect both frames to the center rails by inserting the short steel tube which is pre-attached to the frame into the center rail.

1/2

Marble and Metal Floor Storage

B. M5x10mm Bolt (24pcs)

E. Center Rail (6pcs)

C. Ø10mm Metal Washer (24pcs)

F. Marble Shelf with pre-attached metal pins (3pcs)

Table of Contents

Do you have a question about the Marble and Metal Floor Storage and is the answer not in the manual?

Page 1 Marble and Metal Floor Storage ● Please read all instructions carefully and completely before beginning assembly. ● Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware. ● Use the parts and hardware lists to identify and separate each of the components included.
Page 2 Marble and Metal Floor Storage 3. Secure the center rails to the frame using the bolts (B) and metal washers (C). Tighten with the enclosed Allen key (A). 4. Place marble shelves (with metal pin side down) by holding at a slightly tilted angle and inserting onto frame.