Toro Groundsmaster 3500 30807 Service Manual page 189

Removal (Fig. 88)
WARNING
Before disconnecting or performing any work
on the hydraulic system, all pressure in the
system must be relieved. See Relieving Hy-
draulic System Pressure in the General Infor-
mation section.
1. Remove rear lift cylinder from the frame and lift arm.
2. If hydraulic fittings are to be removed from lift cylin-
der, note and mark fitting orientation to allow correct as-
sembly.
Groundsmaster 3500
Installation
1. If hydraulic fittings were removed from lift cylinder,
install fittings to cylinder using marks made during the
removal process to properly orientate fittings.
2. Install rear lift cylinder to the frame and lift arm.
3. Make sure hydraulic tank is full. Add correct hydraul-
ic fluid if necessary.
4. Adjust rear lift arm.
Page 5 − 131 Hydraulic System