Table of Contents
Advertisement
TP48200A-HX09A1 and TBC300A-DCA5 Telecom
Power
User Manual
1.
2.
3.
Figure 4-24 Removing the smoke sensor
Step 3 Install a new smoke sensor.
1.
2.
3.
Step 4 Disconnect the ground cable from the ESD wrist strap, and take off the ESD wrist strap and
ESD gloves.
Issue 03 (2019-11-15)
Remove the connected cables from the smoke sensor.
Hold down the button on the smoke sensor and push the smoke sensor in the OPEN
direction.
Unscrew the smoke sensor base.
Properly place the smoke sensor base and tighten the screws for it.
Properly place the new smoke sensor and press and push it in the CLOSE direction.
Reconnect the removed cables to the smoke sensor.
Copyright © Huawei Technologies Co., Ltd.
4 Maintenance
73
Advertisement
Table of Contents
