Setting Up The User Interface - Bosch Rexroth SD301 Manual

Blocked for new applications / Für Neuanwendung gesperrt
3 608 876 621/06.03 | SD301

3 Setting up the user interface

3 Setting up the user
interface
The system display is divided into four sec-
tions (Fig. 2):
– The title bar at the top of the screen (1)
– The display field (2)
– The main menu bar at the bottom of the
screen (3)
– The scrollbar on the right side of the
screen (4) (only accessible with certain
menu options).
Fig. 2:
3.1 Title bar (Fig. 3)
.
1 2
Fig. 3:
3.1.1 Channel address (1)
The left field of the title bar displays the cur-
rently selected controller.
3.1.2 Menu level (2)
The current submenu is displayed in this field.
Thus, in conjunction with the main menu bar,
the current position in the menu tree is visible.
1
2
4
3
3 4 5 6
3.1.3 Program selection (3)
This field is only active when all six
program signals (Prog0-Prog5) in
the SE/SEH PLC table have been
set to the SD301 inputs (SD: 0.0
Prog0 - 0.5 Prog5) and the updat-
ed PLC table has been sent to the
SE/SEH.
Button (3) displays the currently selected
tightening program. Pressing the button dis-
plays all tightening programs
the SE/SEH (max. 48). The program currently
selected is highlighted. The program can be
changed by selecting the number of the re-
quired tightening program.
Fig. 4:
The tightening program selected is pre-
served even if the system is switched off and
switched on again. The program last selected
remains active if the SD301 is removed.
It is not possible to select tightening applica-
tions.
1) The loosening program cannot be se-
lected.
Bosch Rexroth AG 29/48
1)
available on