Verifying Proper Installation - TMC EPIC ET4000 User Manual

Verifying Proper Installation

The following procedure should be used at each telephone to verify proper instal-
lation. Also use this procedure any time you are experiencing difficulty, to test
system configuration and identify possible system connection errors. The phone
must be connected to the AC power supply, line 1 must be connected to the line
1 jack, and the phone must have been assigned an intercom station number.
IMPORTANT: If you ever have a problem with the installation or use of your EPIC
System, please check the following procedure before calling our toll-free cus-
tomer support number for assistance - 1-800-TMC-1638.
First, verify that line 1 is connected to the same telephone number at all the tele-
phones. Do do this, press the line 1 button at one of the telephones. The line 1
LED should be green, the speakerphone LED should be red, and dial tone should
be heard from the speaker. Now go to each of the other stations and make sure
that each line 1 LED is red.
Next, make sure that lines 2, 3 and 4 are connected the same at all the phones
by following the following steps at each telephone:
1. Press the line 1 button. The line 1 LED should be green, the speakerphone
LED should be red, and dial tone should be heard from the speaker.
2. Dial the telephone number for line 2. The line 2 LED should flash slowly. If
the line 2 LED does not flash, then line 2 is improperly connected to this tele-
phone.
3. If this telephone utilizes line 3 and/or line 4, repeat steps 1 and 2, substituting
the respective phone number(s) in step 2.
Installing Your System
9