Advertisement
9
Change a user's code
1
Enter the installer programming mode
Press simultaneously the two buttons "1" and "3" more than 2
1 -
seconds and release them.
A double beep is played and all Status LEDs light up.
2 - Enter installer's code. On sucrebox: 001234
All Status LEDs start flashing and a long beep is played
3 - Press "0 to 9" button to select user's number
4 - Enter new user's code (4 or 6 digits)
5 - Re-enter new user's code
6 -
Press (⑤ to exit programming and save your changes
All LEDs stop flashing and a double beep is played
© 2015 by Honeywell International Inc. All rights reserved.
Advertisement
