Advertisement
9
To change a user's code
1
1 - Press and hold the user number "0 to 9" key for 3 seconds (1 is the
master).
A double beep is played and all LEDs light on.
2 - Enter the master code or present the master tag.
A high beep is played and all status LEDs start flashing.
3 - Enter the code for the new user. A high beep is played.
4 - Re-enter new user's code. A high beep is played.
The programming mode ends automatically.
5 - After a few seconds, a double beep is played and all status LED stop
flashing.
© 2015 by Honeywell International Inc. All rights reserved.
Advertisement
