Advertisement
9
To disable a user's code
1
To disable a user's code and keep the TAG only:
1 - Press and hold the user number "0 to 9" key for 3 seconds (1 is the
master).
A double beep is played and all LEDs light on.
2 - Enter the master code or present the master tag.
A high beep is played and all status LEDs start flashing.
3 - Change the code to 0000 (or 000000 if 6 digits).
4 - Re-enter the code 0000 (or 000000 if 6 digits).
A high beep is played.
5 - After a few seconds, a double beep is played and all status LED stop
flashing.
© 2015 by Honeywell International Inc. All rights reserved.
Advertisement
