Operating Parameters; Communication Parameters - Sungrow EMS200 User Manual

8 WEB Interface
Parameter
NTP parameters

8.7.2 Operating Parameters

Different parameters are set for the system configuration interfaces, and the
running parameter interfaces are different accordingly. Please refer to the
actual interfaces, and details are not described herein.
The Operating Parameters include the following settings.
Parameter
Mode setting
Q-ac regulation
BMS control
Start type
Start & stop
control
Note: The table above includes all parameters that can be set, but actual
configurable parameters and interfaces may vary as per system configuration.

8.7.3 Communication Parameters

The communication parameters include the following settings:
Parameter
Network 1 parameters
Network 2 parameters
parameters
26
Description
After checking
synchronize the time to the NTP server (such as PC and
Internet server)
Set server address and port number
Description
Set to "Running Mode", "Power Control Mode", "Grid
Power", or "Off-Grid power"
That includes "Close", "Power Factor", and "Q-ac Power"
Setting closing or opening of the BMS switch
Set the active or passive mode
Set to start or stop
Description
Default IP address: 192.168.1.100
Default IP address: 192.168.0.100
Set the Modbus parameter and TCP port number
"enable NTP time synchronization",
User Manual