Advertisement
WPTC
illuminate with a green color. This will shine through the cover and be highly visible. If the
tool has been pulled past the click (too much time in the clicked position) the LED on the
circuit board will illuminate with a red color. Under either of the latter two circumstances, the
information will be immediately transmitted to the controller.
Reversible ratchet heads
Even though the ratchet is reversible, the tool only applies measured and controlled torque
in the clockwise direction, so thought must be given to the task to be accomplished before
the ratchet is reversed and the tool used in the counter-clockwise direction. Exceeding the
capacity of the tool in a CCW torque application is likely to damage the tool and is not
covered by warranty.
Cleaning
This wrench should be cleaned with a soft cloth dampened with water. Do not immerse this
tool in liquid or use any solvent other than water to clean the tool.
Presetting, Calibration and Repair
Presetting from our Internal After Sales Centers is available. Contact your Bahco distributor
for details. Parts and factory repair are also available.
INSTRUCTION TO THE USER
This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected..
•
Consult the dealer or an experienced radio/TV technician for help.
This equipment has been certified to comply with the limits for a class B computing device,
pursuant to FCC Rules. Operation with non-approved equipment is likely to result in
interference to radio and TV reception. The user is cautioned that changes and modifications
made to the equipment without the approval of manufacturer could void the user's authority
to operate this equipment.
Advertisement
