Advertisement
WPTC
• Never use this tool to break
fasteners loose.
• Do not use extensions, such
as a pipe, on handle of tool.
• Check that tool capacity
matches or exceeds
each application before
proceeding.
• Verify calibration if dropped.
• Make sure ratchet direction
lever is fully engaged in
correct position.
• Verify calibration of tool
if you know or suspect
its capacity has been
exceeded.
• Do not force head of flex
head drives against stops.
• Always adjust your stance
to prevent a possible fall
should something give while
using tool.
• Do not attempt to recharge
Alkaline cells.
• Store tool in dry place.
• Remove batteries when
storing tool used for periods
longer than 3 months.
WARNING.
Electrical Shock Hazard.
Electrical shock can cause
injury. Metal handle is not
isolated.
Do not use on live electrical
circuits.
SAVE THESE
INSTRUCTIONS
DISCLAIMER
Operation of the tool is not
warranted in an EU member
state if operating instructions
are not in that State's
language.
Contact BAHCO if a
translation is needed.
Advertisement
