Advertisement
IMPORTANT SAFETY INSTRUCTIONS
WARNING.
RISK OF FLYING
PARTICLES.
Over-torquing can cause
breakage. Force against flex
stops on flex head can cause
head breakage. An out of
calibration angle tool can
cause part or tool breakage.
Broken hand tools, sockets
or accessories can cause
injury. Excess force can
cause crowfoot or flare nut
tool slippage.
• Read this manual
completely before using
ELECTRONIC TOOL.
• To insure accuracy, work
must not move in angle
mode.
• For personal safety and to
avoid tool damage, follow
good professional tool
and fastener installation
practices.
• Periodic recalibration is
necessary to maintain
accuracy.
• Wear safety goggles, user
and bystanders.
• Be sure all components,
including all adaptors,
extensions, drivers and
sockets are rated to match
or exceed torque being
applied.
• Observe all equipment,
system and manufacturer's
warnings, cautions and
procedures when using this
tool.
• Use correct size socket for
fastener.
• Do not use sockets showing
wear or cracks.
• Replace fasteners with
rounded corners.
• To avoid damaging tool:
Never use tool with power
off. Always turn ON tool
so applied torque is being
measured.
• Do not press POWER while
torque is applied or while
tool is in motion.
3
Advertisement
