Faucet Installation - Black & Decker Amherst Price Pfister 49 Series Installation Instructions Manual

Thank you for purchasing this Price Pfister product. All Price
Pfister products are carefully engineered, and factory tested
to provide long trouble-free use under normal conditions. This
product is easy to install using basic tools and our easy to follow
illustrated instructions. If you have any questions regarding this
product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Price Pfister
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.
3
3 TOOLS RECOMMENDED
• Plumber's putty • Slotted screwdriver
• Pliers • Adjustable wrench
• Cloth
Your installation may require new supply lines and / or shut-off valves or other
additional tools.
4
A
D
C
F
4 CHECKING THE CONTENTS OF THE BOX
Upon opening the box, check to ensure that all of the following items are included.
A Spout Body B Valve Body
D Pop-Up Assembly E Lift Rod
G Valve Gasket H Spout Locknut
K Valve Washer L Valve Locknut
If any of these items are missing, please contact Price Pfister Consumer Service at
1-800-Pfaucet (1-800-732-8238).
ENGLISH
• Phillips head screwdriver
• Flashlight
B
E
J
H
K
L
G
C Soap Dispenser
F Spout Gasket
J Spout Metal Washer

FAUCET INSTALLATION

5
5A
5B
5 SPOUT BODY INSTALLATION
Insert Lift Rod (5A) into hole at the top of Spout (5B). Place a bead of plumber's
putty in the groove along the bottom outer edge of Plastic Gasket (5C). Place Plastic
Gasket (5C) against the bottom of Spout Body (5D). From above sink and with the
spout facing forward, carefully install the Lift Rod (5A), Shank (5E) through the center
hole of sink (5F).
6
6A
6D
6C
6 SECURING SPOUT BODY
From underneath sink, secure Spout Body (6A) by placing Metal Washer (6B) and
threading Mounting Nut (6C) onto Spout Shank (6D). Make sure that the bumps on
Metal Washer (6B) are facing up. Make sure Lift Rod (6E) moves freely. Be sure Spout
Body (6A) is centered and facing forward and tighten the Mounting Nut (6C) until Spout
Body (6A) is firmly secured to sink.
Caution: Do not over tighten!
2
5D
5C
5E
5A
5F
6E
6B