Installing And Connecting Up - Siemens SIMATIC NET CP 1623 Operating Instructions Manual

Installing and connecting up

Note
Permitted number of CP 1623 modules in a PG/PC
A maximum of four CP 1623 modules can be installed in one PG/PC.
Procedure
To install and connect up the CP 1623 follow the steps outlined below:
NOTICE
When handling the module, make sure that you do not touch the connectors or the
electronic components.
1. Activate the plug-and-play mechanism (if available) in the BIOS on your computer.
2. Turn off your computer and pull out the power cable connector from the socket.
3. Open the housing of the computer as described in the manual for your PG/PC and
remove the cover of a free PCIe slot in your computer.
4. Remove the CP 1623 from its packing.
5. Insert the CP 1623 in the PCIe slot.
Make sure that the CP 1623 is inserted and secured correctly.
6. Close the computer housing as described in the manual accompanying your PG/PC
7. Plug the connecting cable (TP) into one of the two jacks on the front panel of the CP
1623.
8. Plug the power supply connector into the socket again and turn on your computer.
Optional: If required, connect the external power supply to the CP 1623.
Now install the CP 1623 as described in the following section.
CP 1623
Operating Instructions (Compact), 02, A5E01175608
Installing and connecting up
4
11