Cleaning The Motor Unit; Cleaning The Accessories; Troubleshooting - Silvercrest Cook 'N' Mix SSKE 300 A1 User Manual And Service Information

6. Disconnect the power cable (9) plug from the wall outlet.
7. Rinse the blender jug (3) out with plain water.
8. For stubborn food remnants, use the supplied cleaning brush (E) and cleaning sponge (B).
9. Rinse the blender jug (3) out with plain water again.
If, after performing the previous steps, there are still food remnants in the blender jug (3),
proceed as follows: Fill the blender jug (3) with water to the "SOUP MIN 0.5 L" mark. Add a
few drops of lemon juice, close the lid and run the SOUP (CHUNKY) function. Finally, rinse
the blender jug with plain water. Repeat this process until no food remnants remain.

Cleaning the motor unit

Clean the motor unit (6) and the power cable (9) with a dry or damp cloth.
Dry the motor unit (6) well.

Cleaning the accessories

The lid (2), measuring cap (1), egg basket (D) and strainer (C) can be rinsed as normal.
The cleaning brush (E) supplied can be used to clean the holes in the strainer (C).
Dry all parts thoroughly.

Troubleshooting

If your soupmaker does not work as normal, follow the instructions below to try to solve the problem. If
working through the tips below does not fix the fault, please contact our hotline (see "Warranty
information" on page 23).
Risk of electric shock!
Never try to repair the device yourself.
Problem
The soupmaker
does not work.
Possible causes
Mains plug not connected
Blender jug (3) incorrectly
seated on the motor unit (6)
Lid (2) is incorrectly fitted on
the blender jug (3)
Remedy
Connect the mains plug to a live wall outlet.
Place the blender jug (3) onto the motor unit (6)
correctly. See "Attaching the blender jug to the
motor unit" on page 14.
Place the lid (2) onto the blender jug (3)
correctly. See "Filling the blender jug" on page
14.
SilverCrest SSKE 300 A1
English - 21