IBM Power Series Handbook page 156

U7879.001.10ABCDE-P3-C31-T2-L23
The first part of the location code (through the T2 label) represents the physical location code for the
resource that communicates with the target resource. The remainder of the logical location code (L23)
represents exactly which resource is indicated.
Location code format
The location code is an alphanumeric string of variable length, consisting of a series of location
identifiers, separated by a dash. An example of a physical location for a fan is Un-A1.
The first position, represented by Un (where n is equal to any string contained between the U and the
hyphen) in the preceding example, is displayed in one of the forms in the following table.
Note: In location codes, the U is a constant digit; however, the numbered positions following the U are
variables and are dependent on your server. Each column defines the numbers that follow the U in the
beginning of the location code.
Machine type and model number in a location code
Utttt.mmm.sssssss-A1
The leftmost code is always U.
tttt represents the unit type of the enclosure (drawer or
node).
mmm represents the model of the enclosure.
sssssss represents the serial number for the enclosure.
Note: The mmm or ccc number might not be displayed on all location codes for all servers. If the mmm value is not
displayed, the location code is displayed in one of the following forms:
v Utttt.sssssss-A1
v Uffff.sssssss-A1
The location code is hierarchical; that is, each location identifier in the string represents a physical part.
The order (from left to right), in which each identifier is shown, allows you to determine which parts
contain other parts in the string.
The dash (-) separator character represents a relationship between two components in the unit. In the
example of the fan, whose location code is Un-A1, the dash shows that the fan (A1) is contained in the
base unit (or Un). Modules, adapters, cables, and devices are all parts that are plugged into another part.
Their location codes will always show that they are plugged into another part as components of the
server. Another example follows:, Un-P1-C9 is a memory DIMM, with memory DIMM (C9) plugged into
a backplane (P1), which is inside the unit (Un).
Note: For devices, certain error conditions might cause an IBM i device to display the device location in
an AIX format.
Table 39. Unit type and locations
Unit type (Utttt.mmm)
U5802.001
U5877.001
144
Finding parts, locations, and addresses
Link to location information
Locations
Locations
Feature codes and sequence numbers in a location code
Uffff.ccc.sssssss-A1
The leftmost code is always U.
ffff represents the feature code of the enclosure (drawer
or node).
ccc represents the sequence number of the enclosure .
sssssss represents the serial number of the enclosure.