Electrical Characteristics; Pellet Loading - EdilKamin INPELLET 49 Installation, Use And Maintenance Manual

Nominal power
Ef ciency nominal power
Emissions O (1 % O ) nominal power
Smo e mass nominal power
Reduced power
Ef ciency reduced power
Emissions O (1 % O ) reduced power
Smo e mass reduced power
a imum overheated smo e
inimum draught
utonomy (min/ma )
Fuel consumption (min/ma )
opper capacity
eatable volume
eight including pac aging
Smo e outlet pipe diameter (male)
ir inta e pipe diameter (male)
* The heatable room dimensions are calculated home insulation in compliance with Italian law 1 /91, and subsequent changes
together with an e pected heat output of
It is also important to consider the position of the insert in the room to be heated.
N.B.
) bear in mind that e ternal devices may cause interference.
2) caution: live parts. Servicing and/or inspections must be carried out by uali ed staff.
Power supply
verage power consumed
Power consumed upon ignition
Remote control frequency
Protection on electronic board
The data shown above is purely indicative. EDILKAMIN s.p.a. reserves the right to make changes to these products
to improve their performance with no prior warning.

PELLET LOADING

The hopper is lled via the loader door (P),
The door is held closed by a magnet; to open/close use the holes on it.
Pour the pellets directly from the bag (about half a bag) or through a bailer
(scoop provided).
hec to ma e sure that all the pellets poured in have reached the hopper
without becoming bloc ed in the e ible tube and then pour in the remaining
half of the bag.
FEATURES
THERMO TECHNICAL CHARACTERISTICS
cal/m³ per hour.

ELECTRICAL CHARACTERISTICS

1
4
ed on the mantel.
- 25
-
,
91,8
4 ,9
4,
1,9
9 ,8
8 ,
,4
1
1
, /
, / 1,
1
1
1
8
ac /- 1 % z
Radio waves ,4 z
Fuse T, ac
P
%
ppm
g/s
%
ppm
g/s
Pa
hours
g/h
g
m³
g
mm
mm