Samsung SINGLE AC MNMSEH/EU Series Technical Data Book page 52

14. Installation
Indoor Unit
Step 16 Setting the indoor unit option code
In order to set the indoor unit option code use the wired
remote controller and follow the directions below.
Main Menu Sub-menu
Page number
Option Code
SEG1 SEG2
0 ∗
Page number
SEG7 SEG8
1 ∗
Page number
SEG13 SEG14
2 ∗
Page number
SEG19 SEG20
3 ∗
Page number
52
Data bit
5 6 1 2 3 4
Option Code
5 6 1 2 3 4
SEG3 SEG4 SEG5
∗ ∗ ∗
SEG9 SEG10 SEG11
∗ ∗ ∗
SEG15 SEG16 SEG17
∗ ∗ ∗
SEG21 SEG22 SEG23
∗ ∗ ∗
1 Press the
than 3 seconds and then a Main menu will be displayed.
2 Press the
button to enter a Sub-menu setting screen.
3 Press the
button to enter a Indoor unit option code setting screen.
NOTE
• The first digit represents the page number and the
remaining five digits are option codes.
• The option code which is currently setting will flicker.
4 Press the
Press button to go to the next page.
5 Press the
setting.
6 Press the
NOTE
• Press the
setting.
CAUTION
• Option code will not be applied if you don't press the
• Setting indoor unit option code is only possible in Master
wired remote controller. You can only check the indoor
unit option code in Slave wired remote controller.
• Setting indoor unit option code is possible when one
indoor unit is connected. If more than 2 indoor units are
connected, you can only check the Master indoor unit
option code.
SEG6
∗
SEG12
∗
SEG18
∗
SEG24
∗
and buttons at the same time for more
/ button to select and then press
/ button to select and then press
/ button to set the option code in order.
button to save and complete the option
button to exit to normal mode.
button anytime during setup to exit without