NEC Bull NovaScale R620 Series Setup Manual page 70

6. Open the [Security] property sheet and make settings as follows;
•
Add the community name entered in Step 4 to [Accepted community names].
•
Set its authority to [READ CREATE] or [READ WRITE].
•
Select [Accept SNMP packets from any host.]
IMPORTANT:
If you entered any community name other than "public" in Step 4, add that name to "Accepted
community names".
Unless you set the acceptable community's authority to "READ CREATE" or "READ WRITE,"
you cannot perform monitoring from ESMPRO Manager.
< Setup of receiving SNMP packets from specific hosts only >
Select [Accept SNMP packets from these hosts], specify IP addresses of the hosts, IP addresses of the
servers to install Agent, and the loop-back address (127.0.0.1).
< Setup of receiving SNMP packets from specific communities only >
Change the name of the community receiving SNMP packets from the default "public" to any name.
IMPORTANT:
If the community name is changed, the community of ESMPRO Agent is changed and
registered by starting from [Control Panel]. To change the community to another and
register it, use the [SNMP Community] list box in the [General] tab.
To allow ESMPRO Agent to receive SNMP packets sent from ESMPRO Manager, set the
send community name in ESMPRO Manager to be the same as that accepted by the SNMP
Service in ESMPRO Agent.
7. Terminate the network setup.
IMPORTANT:
During OS installation, if the SNMP service is added to the system after applying the service
package during OS installation, apply it again. If not, the SNMP service may not operate
properly, and this can cause the improper operation of ESMPRO Agent.
The SNMP Service is required for operating ESMPRO Agent. If the SNMP Service is deleted
after the installation of ESMPRO Agent, install the SNMP Service and then reinstall
ESMPRO Agent.
Some software products provided by other vendors use the SNMP Service. If the SNMP
Service and ESMPRO Agent are installed in the system in which such software as above is
installed, it may be impossible to start ESMPRO Agent services. If so, delete the SNMP
Service once and install the service again. After which, reinstall ESMPRO Agent and the other
vendor's software.
NovaScale R620-LR / R620-MR Setup Guide
5-4