Motherboard Installation; Tools Needed; Location Of Mounting Holes - Supermicro A2SAP-H User Manual

2.2 Motherboard Installation

All motherboards have standard mounting holes to fit different types of chassis. Make sure
that the locations of all the mounting holes for both the motherboard and the chassis match.
Although a chassis may have both plastic and metal mounting fasteners, metal ones are
highly recommended because they ground the motherboard to the chassis. Make sure that
the metal standoffs click in or are screwed in tightly.
Phillips Screwdriver (1)

Tools Needed

JPWR1
JDC
SRW2
JMD1

Location of Mounting Holes

Note: 1) To avoid damaging the motherboard and its components, please do not use
a force greater than 8 lb/inch on each mounting screw during motherboard installation.
2) Some components are very close to the mounting holes. Please take precautionary
measures to avoid damaging these components when installing the motherboard to
the chassis.
Phillips Screws (4)
JHDMI1
JUSB1
USB2/3 (3.0)
Rev:1.01
DESIGNED IN USA
LED1
JGP1
J6: USB0/1
JF1
23
Chapter 2: Installation
Standoffs (4)
Only if Needed
JLAN1
JLAN2
SRW1
JMP1
JLCDPWR1
JCOM1: COM1/COM2 J3: AUDIO FP
BT1