Advertisement
31833146.fm Page 8 Monday, December 20, 2004 2:58 PM
AKR 801
1. Control panel.
2. Grease filter.
3. Halogen bulbs.
4. Steam deflector.
5. Telescopic flue.
6. Spring release handle f.
Analog or digital control panel
Light
:
Press button to switch on.
Extraction speed
:
Press the next button to increase extraction speed.
Maintenance
ALWAYS disconnect the hood from the mains before
performing maintenance.
Wash the grease filter and the carbon filter in a
dishwasher once a month, at the highest possible
temperature, using normal dishwasher detergent.
Wash the filters separately.
After washing, reactivate the carbon filter by drying
it in the oven at 100 °C for 10 minutes. Fit a new
carbon filter every 3 years.
Remove the grease filters - Fig. 1: push the spring
release handle backwards (f)
then remove the filter downwards).
Clean the perimeter extraction panel
(if provided) as often as the grease filter, using a
cloth and a mild liquid detergent.
Never use abrasive substances.
Replacing bulbs
1. Use a small screwdriver or any other suitable tool
to prise off (m-Fig. 1) the lamp cover (p-Fig.1).
2. Remove the burnt-out bulb.
Use max 20 W halogen bulbs only, taking care not
to touch them with your hands.
3. Close the lighting unit (snap-on).
Fitting the carbon filter:
1. Remove the grease filter (Fig. 1).
2. Remove the filter holder by turning the knobs
(g - Fig. 2) through 90°.
3. Fit the carbon filter (h - Fig. 2) in the filter holder
(i - Fig.2).
Reverse the above procedure to re-fit the filter holder
and grease filter.
5019 318 33146
PRODUCT SHEET
D
GB
F
NL
E
P
I
GR
Fig. 1
Fig. 2
Advertisement
