Connecting Video-Interface And Can-Box - r.LiNK RL2-MMI3G-Q3 Manual

2.3.

Connecting Video-interface and CAN-box

The CAN-box reads digital signals from the CAN-Bus and converts them for the video-
interface. ACC +12V max. 0.5A (red wire of 6pin) and reverse gear +12V max. 0.5A (green
wire of 6pin) constant signal.
Note: It is possible to use the interface without MMI-box. In this case sort the female 8pin
connector out from the 6pin to 8pin cable.
Connect black female 4pin Micro-Fit connector of the PNP power/CAN cable to the
male 4pin Micro-Fit connector of the CAN-box.
Connect white female 6pin connector of the 6pin to 8pin cable to the male 6pin
connector of the video-interface.
Connect black female 8pin Micro-Fit connector of the 6pin to 8pin cable to male 8pin
Micro-Fit connector of the MMI-box.
Note: Check LEDs on video-interface after reconnecting the battery, one must be on.
Connect the separate white cable to MMI signal – only for alternative switching of
sources by NAV button in the centre console, if existing (only for MMI 3G, not for
MMI 3G+ or RNS850).
Connect the red and green twisted wire of 6Pin to 8Pin cables to 4Pin female
connector of Video-Interface.
Version 12.01.2018 RL2-MMI3G-xxx