Rl2-Mmi3G-Gw - Connection To The Can-Gateway - r.LiNK RL2-MMI3G-Q3 Manual

2.4.2. RL2-MMI3G-GW – Connection to the CAN-gateway
Remove the female connector CAN-gateway of the vehicle harness from the rear of
the CAN-gatewayHead-unit and connect it to the male connector of the PNP
power/CAN cable.
Pin diagram
4pin cable
•
CAN Low brown
•
CAN High blue
•
Masse
Note: In case of difficulties with the connection of the PNP Power harness; the enclosed
stripped 4pin harness can be soldered to the upper shown cables of the gateway. The 4pin
cable diagram is shown below:
Version 12.01.2018
Pin diagram
CAN-gateway
••
Pin 5 orange/grey
••
Pin 6 orange/bown
••
Pin 15 orange/green
••
Pin 22 orange/blue
Pin 10 of the Quadlock!
(Audi A6 vehicles)
(Audi A6 vehicles)
CAN-gateway
RL2-MMI3G-xxx