Table of Contents
Advertisement
Connect female connector of PNP power/CAN cable to the male connector of CAN-
gateway.
Location of CAN-gateway
• A1/A3
below the steering-wheel
• A6/A7/A8
footwell on the passenger side below right (A6 from 2013 middle of
rear bench seat)
• Q5/Q3
footwell on the passenger side top left
2.4.3. RNS850 – Cable with open ends
For installation in VW vehicles with RNS850 use the additional 4pin power cable with open
ends. The PNP power/CAN cable isn't needed.
Connect the stripped ends of the 4pin cable to ground, battery +12V, CAN high and
CAN low of the climate control unit harness without cutting the cables of the vehicle
harness.
The following pin diagram shows pins and cable colours:
There`s no liability for the vehicle`s pin diagram!
Changes in the manufacturer`s production are possible any time. The mentioned
information has to be verified by the installer.
Version 12.01.2018
Location under the steering-wheel
Pin-diagramm
4pin cable
• grey
••
CAN Low
• blue
••
CAN High
Pin diagram
CAN-gateway
Pin 3
orange
/brown
Pin 2
orange/violett
RL2-MMI3G-xxx
Advertisement
Table of Contents
