Table of Contents
Advertisement
2.8
Picture settings and guide lines
The picture settings are adjusted by the 3 buttons on the video-interface. Press the MENU
button to open the OSD settings menu or to switch to the next menu item. Press UP and
DOWN change the selected value. The buttons are embedded in the housing to avoid
accidental changes during or after installation. Picture settings must be done separately for
RGB, AV1 and AV2 while the corresponding input is selected and visible on the monitor. AV2
and CAM share the same settings which must be adjusted in AV2.
Note: The OSD menu is only shown when a working video source is connected to the
selected video-input of the interface.
The following settings are available:
Brightness
Contrast
Saturation
Position H (horizontal)
Position V (vertical)
Guide CNTRL
=
GUIDE ON
=
PDC ON
=
ALL ON
=
ALL OFF
=
Note: If the CAN-box does not support the very vehicle, the guide-lines cannot be used. PDC
function is only available in a few cars.
Version 12.01.2018
Guide lines for rear-view camera
Guide lines enabled
PDC display activated (function is only available in a few cars)
Guide lines and PDC enabled (PDC see above)
Guide lines and PDC deactivated
RL2-MMI3G-xxx
Advertisement
Table of Contents
