DURKOPP ADLER M-TYPE PREMIUM User Training Manual page 48

Edit Mode: Modify an existing program (cont.)

• Modify segment parameters

• Navigate on the desired seam section number and press

• "New" Parameters not shown in manual mode

• StitchCount – predefine the no. of stitches for the section

• Seg.End Modes

should happen at the end of this seam section)

• Stop On/Off – Sewing stops at the end of the seam section when

switching to the next section.

• Thread Trim – thread cutting at the end of the section

• Needle Up – Needle position at the end of the section

• Foot Lifted – Foot lift at the end of the section

• FL height – Foot lift height

• Backwards

– Segment End Modes (any adjustment of what

– backwards sewn stitches (On/Off)