Maintenance; Troubleshooting - Black & Decker VPX1101 Instruction Manual

90519813 VPX1101 Screwdriver
but not so much that you crack the brittle material. A smooth, even flow of dust indicates
the proper drilling rate.

MAINTENANCE

Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement
parts.
Problem
• Unit will not start.
• Battery pack will not charge. • Battery pack not inserted into charger. • Insert battery pack into
For assistance with your product, visit our website www.blackanddecker.com for the location of the
service center nearest you or call the BLACK & DECKER help line at 1-800-544 6986.
ACCESSORIES
Recommended accessories for use with your tool are available from your local dealer or
authorized service center. If you need assistance regarding accessories, please call:
WARNING:
1-800-544-6986.
with this tool could be hazardous.
7/11/07 8:47 AM

TROUBLESHOOTING

Possible Cause
• Battery pack not installed properly.
• Battery pack not charged.
• Charger not plugged in.
• Surrounding air temperature.
• Battery pack too hot or too cold.
The use of any accessory not recommended for use
11
Page 11
Possible Solution
• Check battery pack
installation.
• Check battery pack
charging requirements.
charger until red LED appears.
• Plug charger into a working
outlet. Refer to "Important
Charging Notes" for more
details.
• If chargers are daisy chained
together check all connections.
• Check current at receptacle
by plugging in a lamp or other
appliance.
• Check to see if receptacle
is connected to a light
switch which turns power off
when you turn out the lights.
• Move charger and battery
to a surrounding air
temperature of above 40
degrees F (4,5°C) or below
105 degrees F (+40,5°C).
• The charger will not
charge a battery pack if the
cell temperature is below
approximately 32° F (0° C)
or above 140° F (60° C).
The battery pack should be
left in the charger and the
charger will begin to charge
automatically when the cell
temperature warms up or
cools down.