Motorola T4512 Manual page 6

6864237V01_EN.fm Page 6 Monday, May 15, 2006 2:36 PM
Optimal Range Medium Range
Outdoors Outdoors
Flat, open areas Buildings or trees.
Also near
residential
buildings
Monitoring Channel Activity
It is good radio etiquette to monitor the channel for
activity before you transmit, to ensure that you do not
interrupt other users already on the channel.
Pressing 6 times allows you to monitor your
\
channel for activity. If you hear static, the channel is
clear for use. Obstacles that block the signal path may
affect the strength of the incoming signal.
Selecting a Radio Channel
1.Press . The channel number will begin to flash.
\
2.Use ] or [ to change channel.
3.Press Mto set new channel.
Interference Eliminator Code
Interference eliminator codes help minimize
interference by providing you with a choice of code
combinations.You can specify a different code for each
channel.
6
1.Press until the code number begins to flash.
\
2.Use ] or [ to change the code.
3.Press Mto set new code.
You can specify a different code for each channel:
Minimal Range
1.To set a channel and code combination, press
Outdoors
and then press ] or [ to select the channel.
Dense foliage or
2.Press again and then press ] or [ to select a
mountains. Also \
inside some
code.
buildings
3.Press Mor press and hold
to save the channel and code combination.
4.To set another channel and code combination,
repeat these steps.
Scan
1.To start scanning, press
appears in the display.
2.Select Y to start scanning or < to stop scaning
3.When activity is detected on a channel, the radio will
stop scanning and you will hear whatever transmis-
sions are detected.
4.If you want to respond to the transmission, press M
within 5 seconds.
5.If scan stops on a channel that you don't want to lis-
ten to,briefly press ] or [ to resume scanning for
the next active channel.
6.To exit scan mode, press
appears and then select < to stop scanning.
\
to exit the menu and
\
4 times until h
\
4 times until
\ h