Advertisement
Implementation
(creation of the connection between the thermostat and the radio socket):
Plug the radio socket into a grounded standard wall outlet 230V/50Hz.
Ensure that the distance between the thermostat and the outlet is more than 50 cm (during this step only).
Press for more than 4 seconds the activation button. The LED flashes red meaning the unit is in learning mode.
Press the center scroll wheel (round) of the thermostat until you see AC on the display. The connection is made!
Switching the heater on:
Press the symbol
Turn the scroll wheel until you reach the desired temperature.
Wait approximately 1 minute for the socket to trigger the heater.
Once the desired temperature is reached, the thermostat sends the order to the socket to stop the heater.
Resetting the thermostat socket (loss of connection)
If you were to restart the setting (loss of connection, power failure, etc.) you would have to reset the socket. To
do that, press at least for 4 seconds the activation button until the LED starts to flash. Release the button.
Press the button again for about 5 seconds until the LED flashes quickly, indicating the unit has resumed its
factory settings. Release the button.
You can then re-create a new connection with the thermostat following the procedure described previously.
For further information, refer to the manual supplied with the appliance.
www.degxel.com
once until you see MANU displayed over the temperature.
Page 7
Advertisement
