Advertisement
OPTION 2: Wireless Programmable Room Thermostat + Radio receiver
Overview
Perform the connection after turning off the power. The goal is to insert the radio receiver into the wall socket
which is to be located behind the heater (for aesthetic reasons). If the electrical outlet is equipped with a front
panel, you need to remove it in order to insert the receiver inside. Remove the cover of the wall socket and unhook
the 3 power supply wires. Please note that the white box delivered with the receiver is useless for your config-
uration (do not use it). Using a wire cutter, cut off, free and stripp the 3 wires (N =Neutral=Blue, L=Live=Brown,
E=Earth=Ground=Yellow/Green).
Connection diagram
As indicated on the diagram below, the Neutral (N) wire from source has 2 departures (divided in 2 parts). Use a
domino or a wago terminal to make 2 departures from the Live (L) and 2 departures from Neutral (N) for connect-
ing on the receiver and the heater. Do not forget to connect the ground wire (green-yellow) of the heater with the
ground wire of the power supply (not present in this diagram).
www.degxel.co.uk/tutorial
WIRELESS
PROGRAMMABLE
ROOM
THERMOSTAT
RADIO RECEIVER 1
CANAL ON/OFF
www.degxel.com
Page 9
Advertisement
