Advertisement
STAGE 1 |
PAIRING THE ROOM THERMOSTAT WITH A RECEIVER
This step is also described in the following video: www.degxel.co.uk/tutorial
Do not hesitate to consult it if you have operating problems.
In order for the thermostat to communicate with the heater it's necessary to perform this step.
Without the coupling operation between the thermostat and the receiver there won't be any communication be-
tween them two. Therefore, the heater won't work. Similarly, if you experience operating problems in the future, we
advise you to repeat this step.
On the receiver, perform the following step:
Press for 5-6 seconds (not more) the central button, a RED light lights up AND fl ashes slowly = the receiver is
put in learning
mode. Remove the pencil.
Light : Indication of the status of the
pairing with a room thermostat
Button : Pairing mode button for
pairing with a room thermostat
On the thermostat, perform the following steps:
RADIO TRANSMISSION
1 |
On the room thermostat, press
On the room thermostat, press
and hold it down for 3 secondes to carry out pairing.
MEMO will be displayed.
Page 10
button
button
2 |
Press
Press
radiowave confi guration message and the
radiowave confi guration message and the
be displayed briefl y.
. The room thermostat will then send a
. The room thermostat will then send a
www.degxel.com
icon will
icon will
Advertisement
