Troubleshooting - Renkforce Joystick 1359969 Operating Instructions Manual

12. Troubleshooting

With this DMX controller, you purchased a product built to the state of the art and operationally safe. Nev-
ertheless, problems or errors may occur. Therefore, we would like to describe how to eliminate possible
errors here:
Always observe the safety information!
Device does not work after the POWER switch (26) was switched on
• The mains adapter is not plugged into the socket correctly
• The mains adapter connection line is properly connected to the device's DC INPUT port (25).
• The mains socket is not supplied with current.
The connected effect lights do not work
• Blackout mode is active, and the LED next to the BLACKOUT button (11) flashes.
• The DMX addresses are set wrongly.
• The connection between the DMX controller and the connected effect lights is interrupted.
• The DMX POLARITY SELECT switch (22) is in the wrong position. Check the DMX plug assignment of your
effect lights.
• The DMX line is too long or subject to interference. Use a special DMX high frequency line.
The sound to light control does not work
• Sound to light control is deactivated. Press the MUSIC/BANK COPY button (4); the MUSIC display must
appear in the mode display (8).
• Music playback volume is too low. Try upping the volume.
50